Aquamura is designed for straightforward installation. For a more detailed guide download our PDFs at the bottom of this page.
01
Aquamura panels have an attractive, tough laminate surface, and are constructed from quality water resistant plywood.
02
For best results with Aquamura panels, start in corner and finish over doorway.
03
Inspect panel and remove plastic film before fitting. Do not fit panel if any issue is found – report to supplier immediately
04
Once panel has been inspected and any necessary cutting completed, apply glue to back of panel – approx 1 x 310ml cartridge per 2400 x 1200 panel.
05
In order to ensure a watertight seal, put a thin bead of silicone in the trim and slot panel into trim.
06
Press panel back to wall and CSK screw down length of grooves end. Use appropriate fixings depending on material of wall.
07
Apply thin bead of colour sealant into tongue edge of panel joint before fitting next panels. (Leave excess on face of panel to dry overnight and clean off
the next day.)
08
Slide the panel into place.
09
Cut last panel of each wall to size. Silicone edge, fit profile and swing into place.
10
Mark position of final piece symmetrically over doorway. Cut panels and fix. Glue and screw where heads will be hidden by door moulding or coving.
