specification & fitting

specifications

materials

Core material: Birch plywood
Face material: High pressure decorative laminate
Reverse: Balancing laminate

dimensions

Standard Panel Size: 2400 x 590 x 11mm T&G Weight: 12kg
Shower Panel Size: 2400 x 1200 x 11mm Square Cut Weight: 24kg

fire performance

Aquamura complies with Class II surface spread of flame

accessories

Aluminium jointing sections are available in 2500mm lengths in a variety of finishes:

S.A.A., Polished Aluminium, Black, White and Polished Gold effect.

fitting shower panels

Shower Panels should be trimmed to the correct height and width, and then installed resting on the shower tray, embedded in silicon.

Panels can be glued back to wall battens, or glued directly onto a suitable wall. Aluminium internal corner jointers and end caps are recommended, with sealant applied into the extrusion.

fitting standard tongue and grooved panels

one Aquamura panels have an attractive, tough laminate surface, and are constructed from quality water resistant plywood.	two For best results with Aquamura panels, start in corner and finish over doorway.	three Glue down edge of panel and fix into corner profile.	four Nail or screw down length of tongue. Use appropriate plugs for concrete, brick or plaster.
five Apply sealant in joint before fitting next panel.	six Slide the panel into place.	seven Cut last panel of each wall to size. Glue edge, fit profile and swing into place.	eight Mark position of final piece symmetrically over doorway. Cut panels and fix. Glue and nail where heads will be hidden by door moulding or coving.

one

Aquamura panels have an attractive, tough laminate surface, and are constructed from quality water resistant plywood.

two

For best results with Aquamura panels, start in corner and finish over doorway.

three

Glue down edge of panel and fix into corner profile.

four

Nail or screw down length of tongue. Use appropriate plugs for concrete, brick or plaster.

five

Apply sealant in joint before fitting next panel.

six

Slide the panel into place.

seven

Cut last panel of each wall to size. Glue edge, fit profile and swing into place.

eight

Mark position of final piece symmetrically over doorway. Cut panels and fix. Glue and nail where heads will be hidden by door moulding or coving.